Call now to get tree supporting such as tree cleanup, tree cutting, bush lop, shrub trim, stump contractor and lots more around United States


Call now

Call +1 (855) 280-15-30










Our Turn-Key ZZ4 crate engine also ships with all the parts you need.

GMC Sierra L with M Series Transfer Case / with MP Series Transfer CaseRear Transfer Case Housing by USA Standard Gear. Put your vehicle back to its original condition with this top-notch transfer case component. 1A Auto shows you how change your 4 wheel drive transfer case fluid. This video is applicable to Chevy Silverado and GMC Sierra models.🔧 List of tools used.

We changed the fluid on this HD GMC. We used Amsoil fuel-efficient ATF Signature Series. Playlist on the other fluid changes on this GMC Sierr. Feb 25, The tranny will drip a little bit. It's only those 6 bolts, linkage, wiring, and shafts. If you can't get a wrench on the top bolts put a Jack under the tranny crossmember and unbolt crossmmber from frame and lower it a little. Leave Jack under it so you don't put all that stress on the motor bushtrimmers.buzzted Reading Time: 5 mins.

1A Auto shows you how to repair, install, fix, change or replace a transfer case shift motor that is not working, engaging or is defective. This video is app. Designed to send the engine power to both the front and rear axles Direct-fit replacement for your overworked, out-of-shape transfer case.-USA Standard Gear Transfer Case Input Shaft. 0. # sp Transfer Case Input Shaft by USA Standard Gear. Transfer Case Studies: Diagnosing GM's 4WD System. Access to DTCs can simplify any system diagnosis.

But as two separate cases on GM's 4WD system reveal, these codes are not always % accurate. GM has used many different four-wheel-drive control systems in its vehicles over the years, ranging from pure mechanical to electronically controlled. Feb 14, Insert a screwdriver into the slot on the right side of the transfer case. With equal pressure applied on each screwdriver, separate the front half and the rear half.

Using snap ring pliers, release the outside retaining ring for the rear output shaft bearing. Remove the rear case half from the front case.